Engineers and site teams usually ask us the same thing: “We have a 100 mm gap on the second floor. What do we use?” Choosing an expansion joint cover comes down to three questions.
- How wide is the gap? Measure the actual gap on site; it is often different from the drawing.
- Where is it? Floor, wall, ceiling, roof or parking deck.
- What will cross it? Foot traffic, hospital beds and trolleys, or cars.
Floor joints: quick selection table
| Gap | Recommended system | Load | Fix |
|---|---|---|---|
| 25 – 50 mm | SE-AFRPB 50 (aluminium + EPDM insert) | 30 – 300 kN | Before tiling |
| 50 – 55 mm | SE-AFPA 50 surface cover | 30 kN | After tiling |
| 75 – 100 mm | SE-AFPA 75–100 sliding cover | 5 kN | After tiling |
| 25 – 200 mm | Extruded aluminium cover 4–5.2 mm | 30 – 300 kN | After tiling |
| 200 mm | SE-AFPB heavy-duty, 6 mm plate | 500 kN | Before tiling |
| 50 – 300 mm | SS 304 parking / podium joint | Vehicle | Either |
| 100 – 300 mm | GI centre plate system with EPDM | 30 – 300 kN | Before tiling |
Wall and ceiling joints
Walls and ceilings don’t carry traffic, so the choice is mainly about looks and how much the joint moves:
- 25 – 100 mm: SE-AW clip profile. It presses in with spring-steel clips and has no visible screws.
- 25 – 250 mm: SE-AWC powder-coated cover, available in any colour to match the façade.
- 50 – 300 mm: wall/ceiling cover profile on GI self-aligning clamps, for ±25 mm movement on seismic façades.
Roof joints
Roof joints must be watertight first and good-looking second. We bond an EPDM barrier into the gap with Mapei Adesilex epoxy, then fit an aluminium L-profile and top cover. This works for 25 – 200 mm gaps with ±25 mm movement.
Before or after tiling?
This matters for programming the work. Flush systems such as SE-AFRPB and SE-AFPB are fixed before the floor finish, so the tiler works up to them. Surface covers such as SE-AFPA go on after tiling. If the floor is already finished, a surface cover is usually the only practical option.
Tip: always ask the structural consultant for the expected movement (±mm) as well as the gap width. Two 100 mm joints can need very different systems.
Need help choosing a joint for your project? Send us the joint width and location or call +91 98187 49056. We usually reply with a recommendation the same day.