SS 304 floor expansion joint for parking, podium and driveway

Aluminium vs SS 304 Expansion Joint Covers: Which Should You Use?

Almost every expansion joint cover we supply is made of either extruded aluminium 6063-T6 or stainless steel grade 304. Here is a straightforward comparison.

Aluminium 6063-T6SS 304
WeightLight, easy to handleAbout 3× heavier
StrengthGood; ratings up to 500 kN with the right sectionVery high surface hardness
CorrosionExcellent, especially when anodisedExcellent
FinishMill, anodised silver or any powder-coat colourMatt or brushed steel
CostLowerHigher
Best forMost floors, walls, ceilings and roofsParking, podiums, driveways and high-wear areas

When we recommend aluminium

For most hospitals, colleges, offices and residential projects, aluminium is the sensible choice. We use Hindalco extrusions made to ASTM B221, and the profiles can be shaped with ribs for grip, internal channels for EPDM, and self-centring cavities. Powder coating lets wall and ceiling covers disappear into the paint scheme.

Aluminium floor expansion joint installed in a stone-paved corridor

When we recommend SS 304

Wherever wheels turn, such as basement ramps, podium driveways and loading areas, stainless steel holds up better to scuffing and point loads. It also suits premium lobbies where a brushed-steel line is part of the design. Our SS 304 covers come in 2–4 mm thicknesses and 125–500 mm widths.

Can you mix them?

Yes. A typical hospital might use aluminium flush joints in the wards, SS 304 covers at the ambulance drop-off, and powder-coated aluminium on the façade. We often supply all three on one project.

Need help choosing a joint for your project? Send us the joint width and location or call +91 98187 49056. We usually reply with a recommendation the same day.

Share this guide:WhatsAppLinkedInFacebookX

Leave a Comment

Your email address will not be published. Required fields are marked *